Official Blackstaramps Forum

Cheers. Will do that.

Does anyone know the spec/ measurement of the new LT series pedals? ie LT Dual, Drive?

No specs seem to be mentioned on the BS main site. Need the specs to calculate my pedal board real estate. Cheers

This is my pedal set-up on the HT5R combo. The effects in the case are always connected to the loop (ie Tuner, Eq, Mod, Delay, Lopper). I always set the HT5R gain channel for an overdrive tone. I use a Wah and distortion pedal on through clean channel for a different voicing. (ie Classic Rock, Moder...

check for clean power supply or even the tubes, also sometimes hum on high gain hum can occur with lighting interface or where the amp is placed.

I don't think there are any new revised HT5.

The only revision done was a couple of years back which i currently have HT5R. (12'' speaker, Digital Reverb, Tone Control-Clean channel, longer foot switch). But hey i may be wrong

I have been using an MXR 6 band eq in my HT5R effects loop to boost the OD channel for solos or even to sculpt scooped mids. For me the EQ is a must have. So many possibilities to play with your tone. Last month i saw a video by guitarist Andy James where he uses the Bad Monkey to boost the blacksta...

my axes

Boss and MXR are both very good. I currently have the MXR 6 band EQ running in the FX loop of my HT5R. Even at high gain i get no noise. Play around with your pedal combinations. Noise factors are power supply, patch cables, guitar pups, earthing, magnetic fields, pedals etc. I have a small pedal se...

My guess 1) Yes you can use the emulated out and an attached speaker same time. 2) Yes you can use only emulated out with speaker attached. when doing this put the amp on Standby and use emulated output. Dont think much. You wont find many valve amps in the market with FX loop, 12'' speaker, Digital...