Hope this helps out I couldn't find any instructions so i thought, after fumbling through and working it out I would make it easier for others.
How to turn the GT-10 into a midi controller
1. On GT-10 press SYSTEM
2. Select MIDI (ENTER)
3. Select SETTING (ENTER)
4. SELECT THE FOLLOWING SETTINGS:
Omni Mode – OFF
TX Channel – Rx
Device ID – 1
Sync Clock – Auto
PC Out – ON
CTL3 out - CC#64
CTL4 out - CC#65
Map Select – Prog
I set my Ctrl 3 & 4 but 1 & 2 can be used too
CC#64 – Modulation On/Off
CC#65 – Delay On/Off
CC#66 – Reverb On/Off
I also go to a patch :
5. Press Master/Pedal FX
6. Choose ASSIGN (ENTER)
7. Choose an assign bank
8. Target: MIDI Start/stop
9. Source: (choose CTL Pedal)
10. SRC Mode: Toggle
11. I left rest a default
12. Repeat for a different assign and CTL Pedal
That is! It worked a treat you can now bring in FX with CTL pedals and move patches with the 1-4 Pedals
Four Cable Method:
Just in case you need this, the 4 cable method into a Blackstar ID series:
GT-10 Amp
Return MP3 Line in
Left mono Emulated Line out
Send Input
Input plug in guitar to this
cheers
Instructions for using GT-10 as a midi controller
-
- Information
-
Who is online
Users browsing this forum: No registered users and 17 guests