My Blackstar HT-distx has gone microphonic. What to do?
As the topic says my pedal has gone microphonic, ie the sound goes muddy at times and then i have to tap the casing to get back to the regular sound. In my world all tubes have a certain lifetime but when i consult the manual it doesnt mention anything about changeing this. So, is the pedal all used up when the tube is? Or are there ways for a mortal to fix this?
-
- Posts: 64
- Joined: Wed Jun 02, 2010 12:00 am
- Location: Australia
- Contact:
really just sound's like your tube has gone off,change the tube as i'm sure that is why it's microphonic same as a valve amp some a just crappy from factory as they do normally put cheap one's in there,get a jj or tungsol they are really reliable and sound good,but there is many that are good... nos etc up to the user what he likes!bezen wrote:As the topic says my pedal has gone microphonic, ie the sound goes muddy at times and then i have to tap the casing to get back to the regular sound. In my world all tubes have a certain lifetime but when i consult the manual it doesnt mention anything about changeing this. So, is the pedal all used up when the tube is? Or are there ways for a mortal to fix this?
Maybe I should rephrase my question a bit. Is there anyone that has experience in changeing a tube i a blackstar pedal? I dont wanna start disassemble it only to found out that its more or less impossible to change the tube or that there are more stuff that needs to be done when changeing the tube.ozguitar wrote:really just sound's like your tube has gone off,change the tube as i'm sure that is why it's microphonic same as a valve amp some a just crappy from factory as they do normally put cheap one's in there,get a jj or tungsol they are really reliable and sound good,but there is many that are good... nos etc up to the user what he likes!
-
- Posts: 64
- Joined: Wed Jun 02, 2010 12:00 am
- Location: Australia
- Contact:
Last edited by Anonymous on Fri Jun 25, 2010 1:29 pm, edited 1 time in total.
For other reasons, I disassembled my HT-Dual. When I removed the board from the chassis, there was the tube. It was pretty easy. Just keep an eye on what you're doing. Because I was looking for something else, I can't remember exactly what the tube side of the board looked like. Typically, if there's not something else securing the tube, its just plugged in. If you decide to do it yourself, make sure you just don't pull the tube without holding the piece its plugged into.. .don't want to yank it off the board! Of course, I'm sure this will void your warranty. I'm sure they only want authorized techs to do this stuff.bezen wrote:Maybe I should rephrase my question a bit. Is there anyone that has experience in changeing a tube i a blackstar pedal? I dont wanna start disassemble it only to found out that its more or less impossible to change the tube or that there are more stuff that needs to be done when changeing the tube.ozguitar wrote:really just sound's like your tube has gone off,change the tube as i'm sure that is why it's microphonic same as a valve amp some a just crappy from factory as they do normally put cheap one's in there,get a jj or tungsol they are really reliable and sound good,but there is many that are good... nos etc up to the user what he likes!
-
- Information
-
Who is online
Users browsing this forum: No registered users and 14 guests