Blackstar with select-able cab schematic
Posted: Wed Jun 26, 2019 9:16 pm
Blackstar with select-able cab schematic
I want to use my HT5 for recordings at home and want to be able to switch between
different cabs (with 1x 16 Ohm Celestion speakers).
I think I need to put a 16 Ohm resistor as a dummy load because there will be short period with no speaker
attached to the amp when switching....
is this correct? do I need more specs/things to consider?
and will the switch work as drawn? with the plus switching and the v- permanently connected with the - of both speakers?
see picture!
and thanks!
I want to use my HT5 for recordings at home and want to be able to switch between
different cabs (with 1x 16 Ohm Celestion speakers).
I think I need to put a 16 Ohm resistor as a dummy load because there will be short period with no speaker
attached to the amp when switching....
is this correct? do I need more specs/things to consider?
and will the switch work as drawn? with the plus switching and the v- permanently connected with the - of both speakers?
see picture!
and thanks!