Said that I'm totally new to MIDI and MIDI pedalboards, I've been trying for days to have my FCB1010 speak to my amp, but nothing happened.
As last tentative, I've reset both to factory defaults, hoping that I could at least recall the first 10 amp patches by pressing the 10 switches, but even if FCB/UnO Control Center utility, MIDI IN monitor, says that I'm actually sending PCs from 0 to 9, the amp does not react (manual mode set).
What am I doing wrong? Or, is my amp broken?
ID100 and FCB1010
maybe it is set to a wrong channel... i dont remember for sure but i thing you should set them to omni mode.. midi is really complicated but if you get familiar with it, it will free your hands with a ton of possibilities
-
- Information
-
Who is online
Users browsing this forum: No registered users and 43 guests