ID Core 60 noise during signal decay

Discussion - ID:Core amplifiers.
Post Reply
davelittlewood
Posts: 1
Joined: Mon Nov 21, 2016 8:29 pm

Mon Nov 21, 2016 8:36 pm

Hi,

Got an ID Core 60 Head going through a Palmer PGA04.

When I strike a note or chord the sound is good, however as the signal from the guitar decays and the amp power reduces there is degradation in the signal.

As the power stage output reduces I can hear a glitch in the signal at the same time as the LEDs on the front of the palmer go out.

I'll try the effects loop output to see if it's in the pre-amp or power stage.

I have tried the palmer with my other head (BS Artisan 15H) and the signal decay is smooth.

Just updated the software on the amp (with the release of the new Insider) but no change.

Tried all the different channels, AVP on/off, noise gate on/off, makes no difference

Post Reply
  • Information
  • Who is online

    Users browsing this forum: No registered users and 9 guests