I own the id core 10 v1.
I read in the handbook that the "Effects loop feature" can be activated/deactivated from the Insider software
However in the Insider software, I see it detects my amp but I don't have any option to control the Effect loop functionality.
I have no problem with the output if i'm using my headphones or if i'm using the emulated outputs to send signal to an electronic drum console input. For some reaons, the effects loop gets enabled when I'm using a 1/8 male to 1/4 stereo hooked to a roland octo-capture device. Quite annoying.
How can I disable the effect loop?
Thank you
Effects loop or emulated output problem on id core 10
No I dont have any effect in the loop..
to better demonstrate my problem, I recorded a clip of the sound I get when I use the EO to a m-audio fast track pro interface using a 1/8 stereo to a 1/4 stereo cable
http://www.filedropper.com/showdownload ... tereoinput
I believe that what it is recorded is the sound of the "send".
while recording, I was playing with the effect on the id core so you can hear that in the recording. When I was not using any effect at all, I could barely hear the guitar at all even if the volume was at maximum..
thank you
to better demonstrate my problem, I recorded a clip of the sound I get when I use the EO to a m-audio fast track pro interface using a 1/8 stereo to a 1/4 stereo cable
http://www.filedropper.com/showdownload ... tereoinput
I believe that what it is recorded is the sound of the "send".
while recording, I was playing with the effect on the id core so you can hear that in the recording. When I was not using any effect at all, I could barely hear the guitar at all even if the volume was at maximum..
thank you
Last edited by gaud2029 on Wed Jan 11, 2017 4:48 am, edited 1 time in total.
Not an FX loop send
Insider software will gray out options used on other products. IDC100 and 150 have FX loops and use the Insider software so that is probably what you are seeing. It would not be active in the IDC10,20 or 40.
The emulated output on IDC10 should be just basically what you hear in headphones. It's the channel you select, plus any fx, with a type of filter for a cab emulation.
Insider software will gray out options used on other products. IDC100 and 150 have FX loops and use the Insider software so that is probably what you are seeing. It would not be active in the IDC10,20 or 40.
The emulated output on IDC10 should be just basically what you hear in headphones. It's the channel you select, plus any fx, with a type of filter for a cab emulation.
-
- Information
-
Who is online
Users browsing this forum: No registered users and 41 guests