Hi Blackstar folks, Bob-I new member here.
I have a Core ID 20 that I’ve used as a practice amp for years. Last week at practice the voice knob stopped working, no change in voice and no lights changing. I connected to a laptop and through the Insider app everything works correctly. I plugged in a 1/4” jack and shorted the end, it changes voices. I reset to factory defaults, upgraded the firmware and no change.
Other than a hardware failure, is there anything else that I can try to resolve this? I’d hate to just throw this amp out, it’s really handy and sounds petty good.
Thx in advance for your thoughts
Core ID 20 voice knob not working
Last night I tried a simple 2 button footswitch I have, it works. I setup patches in insider, set to alternate mode on the footswitch and it all seems good.
As for dry/cold solder joints. I inspected visually and can’t see any. When I get time I’ll reflow the joints and see if that makes a difference.
As for dry/cold solder joints. I inspected visually and can’t see any. When I get time I’ll reflow the joints and see if that makes a difference.
-
- Information
-
Who is online
Users browsing this forum: No registered users and 6 guests