Architect backup during installation has no patches

This is the place to ask any questions about Blackstar Architect. Users will be able to give you feedback and advice.
Post Reply
docja
Posts: 1
Joined: Sun May 09, 2021 10:22 pm

Mon May 10, 2021 1:45 pm

I installed Architect with my ID:Core 10 V1 with the switch for backup current patches turned on, and it did generate a backup in the patches panel. The new (V3?) Clean Warm amplifier patch is different from the V1 patch (which I like), so I restored the backup, but there were no non-manual patches in the backup. Is there some way to restore the V1 patches individually or as a group, from an online library, for example?

Thanks

Post Reply
  • Information
  • Who is online

    Users browsing this forum: No registered users and 13 guests