Hi all, I recently purchased an ID:Core V2 20 with the foot controller (the FS-11 with the 2 switches). I was hoping to be able to switch between two patches for clean and distorted sound. Although I did manage to save the patches and assign them to the foot controller, I noticed that the patch saves the VOICE, any effects and the GAIN level, but not the VOLUME level. What this means is that if I create a distorted tone, with high gain and low volume, and the a clean tone with low gain and high volume, when I switch between patches (with the foot controller), the gain level is set to whatever the patch is but the volume level stays the same. So, I don't get the sound I was originally aiming for.
Is there a way to save both gain and volume levels in a patch?
TIA.
How to save volume and gain level in patch?
-
- Posts: 2
- Joined: Sat Aug 12, 2023 10:45 am
I also had it recently and I had the same issue but after a few days it got fixed. And it has been a good support for me and the dress that has supported me in winter is this Louis Vuitton Dreaming Varsity Jacket so you should also visit it.
-
- Posts: 3
- Joined: Thu May 02, 2024 6:01 am
Test your reflexes in Helix Jump 2, mastering precision and timing to descend through colorful helixes with speed.
-
- Information
-
Who is online
Users browsing this forum: No registered users and 3 guests