Official Blackstaramps Forum

Hi all, I recently purchased an ID:Core V2 20 with the foot controller (the FS-11 with the 2 switches). I was hoping to be able to switch between two patches for clean and distorted sound. Although I did manage to save the patches and assign them to the foot controller, I noticed that the patch saves the VOICE, any effects and the GAIN level, but not the VOLUME level. What this means is that if I create a distorted tone, with high gain and low volume, and the a clean tone with low gain and high volume, when I switch between patches (with the foot controller), the gain level is set to whatever the patch is but the volume level stays the same. So, I don't get the sound I was originally aiming for.
Is there a way to save both gain and volume levels in a patch?
TIA.

I also had it recently and I had the same issue but after a few days it got fixed. And it has been a good support for me and the dress that has supported me in winter is this Louis Vuitton Dreaming Varsity Jacket so you should also visit it.

Test your reflexes in Helix Jump 2, mastering precision and timing to descend through colorful helixes with speed.