Anyone figure out how to use ID:Core interface w/ Dept 10 pedals?

This is the place to ask any questions about Blackstar Architect. Users will be able to give you feedback and advice.
Post Reply
WittyMonikerHere
Posts: 1
Joined: Wed May 29, 2013 4:13 pm

Fri Dec 02, 2022 11:19 pm

I own a Dept 10 Dual Distortion, which sounds pretty great (especially after fine tuning it w/ the Architect software and going through the CabRig output).

However, the damn thing is suuuuuuuuuper noisy (even with an ISP Decimator after it).

I saw that the ID Core interface has a noise gate built in. Anyone figure out a way to unlock this feature for when you're just hooked up to the pedal (I believe the software auto-detects the product)? But there must be a way to bypass that, right...?

I feel like this would be like the "sneaky amps" hack Katana owners went nuts over a few years ago...

Post Reply
  • Information
  • Who is online

    Users browsing this forum: No registered users and 6 guests