Saving patches with different volumes

This is the place to ask any questions about Blackstar Architect. Users will be able to give you feedback and advice.
Post Reply
Posts: 1
Joined: Thu Jul 29, 2021 5:38 pm

Thu Jul 29, 2021 5:43 pm

Hey Everyone! Loving my Idcore 20 v3. The one thing I can’t figure out is how to have different patches saved with different volumes. I want to have a clean patch and a distorted patch with different volumes. I want the clean to have a lower gain on it but I want to raise the volume to match the distortion patch volume. Every time I go and save the patch it saves everything but the volume. In fact it changes the volume for all the patches so it’s always matched. Does anyone know how to save different volume tones for each patch? Thanks a ton!

Posts: 1
Joined: Thu Dec 23, 2021 12:09 pm

Thu Dec 23, 2021 12:10 pm

Yep - also struggling with this.

Post Reply
  • Information
  • Who is online

    Users browsing this forum: No registered users and 1 guest