Blackstar Architect with two amps

This is the place to ask any questions about Blackstar Architect. Users will be able to give you feedback and advice.
Post Reply
Posts: 1
Joined: Sat Feb 20, 2021 10:04 pm

Tue Aug 24, 2021 10:28 am

I've just connected my two Blackstar amps (ID20v2, ID260) up to my computer via usb.

I started Architect, and it seems that it can only detect the last amp that was switched on. There seems to be no way to switch between amps or to have two instances of Architect running so that I can see and set up both amps simultaneously.

Just curious if there is any way to work with both amps simultaneously?

Thanks, John

Post Reply
  • Information
  • Who is online

    Users browsing this forum: No registered users and 3 guests